Using The Scroll Saw Workshops' Keychain Maker

Posted by Jeremy Walls | | Posted On Tuesday, February 22, 2011 at 6:47 PM





Hi guys,
I thought I would take some time to show you how to make a key chain using Steve Good's program from his site, the Scrollsaw Workshop. If you print off 2 different patterns the same length from the program, and glue them to each side of the wood, you can cut a 3D key chain. Above is a step by step photo slide show of how I did it. Notice in one of the last pictures that the backside of the key chain on both sides is backwards. You can download the program from his site below. Also, go to his site and check out his FREE PATTERN CATALOG. He posts a new free pattern nearly every day.


Scrollsaw Workshop Key Chain Pattern Maker
(THIS IS NOT A PROGRAM OF THE SCROLL BENCH)

Note: Please consider a $5 donation to his site for downloading the program.
This Post Was Mentioned Here: SCROLLSAWWORKSHOP.BLOGSPOT.COM 
Thanks steve!

Comments:

There are 17 comments for Using The Scroll Saw Workshops' Keychain Maker

Post a Comment


Larger Map Here